#Seismic data processing software software

A lot of routines like FK might assume a constant trace spacing in a shot or CDP and come unstuck with your variable offset distribution.ДЄ better aporoach would probably be to regularise the offsets by either a k-filter and trace drop on the first half of the cable (to 16 offsets, 2m spacing) or using an interpoation routine on the second part (to give 32 channels at 1m spacing) if you have a good pre-stack regularisation routine this is probably the best way to go.

#Seismic data processing software software

That said, you will have to be very careful in your processing. With intuitive analysis tools, state-of-the-art geophysical algorithms and an optimized parallel infrastructure, the SeisSpace ProMAX Seismic Processing Software family helps teams get the most out of seismic data, increase productivity, reduce project cycle times and understand even the most difficult geologic targets. and you can then calculate a CDP number from this be dividing by your chosen CDP spacing now you can use the SHOT-X and REC-X values to calculate the midpoint location (SHOT-X + REC-X)/2 calculate the distance along the line for each receiver, which is the shot location minus the offset (cable behind the boat.) and store this as the REC_X header calculate the distance along the line for the shot point so once you have numbered for any missing shots you can just multiply the shotpoint number by 4.0 metres and store this as a header shuch as SHOT_X assign the offset header based on the channel number hopefully you can interpolate this from a table in some way in your software There are many open-source seismic reflection data processing software programs available however, they often use a high-level programming language that decreases its overall performance, lacks intuitive user-interfaces, and is limited to a small set of tasks. That can be tricker - depending on what software you are using. Nevertheless, obtaining high resolution and accurate results requires a sophisticated processing stage. GLOBE Claritas 12 September 2013 at 17:56 InSite Seismic Processor is an integrated seismic data acquisition, processing, management and visualization software for seismological studies ranging from.